PIC-ICD-II |
In Circuit Debugger / Programmer for PIC MCU’s
.
|
|
|
 |
All-in-one debugger/programmer for PIC microcontrollers |
|
USB (Full Speed 2 mbps) & RS-232 interface to host PC |
 |
|
Real time in-circuit debugging |
|
Built in over-voltage/short circuit monitor |
|
Firmware upgradeable from PC |
|
Supports low voltage PIC MCUs from 2.0 volts (2.0V to 6.0V range) |
|
Three Diagnostic LEDs (Power, Busy, Error) |
|
Reading/Writing memory space and EEDATA of target microcontroller |
|
Erase of program memory space with verification |
|
Total peripheral freeze-on-halt (stops timers at breakpoints) |
|
100% compatible with Microchip’s® ICD-2 |
|
User Manual / Installable Software / Useful Links |
Installable Software on CD
|
MPLAB® IDE GUI (free copy included) |
PIC-ICD-II Package Contents
|
Standard package contains the following: |
|
PIC-ICD-II board |
Adapter Board to Program DIPMCU's |
|
Adaptor board to Program DIP MCU’s |
|
RJ11 Cable |
|
An AC adapter |
|
Installation software CD |
|
Serial connecting cable |
|
USB connecting cable |
| |
IC’s supported by PIC-ICD-II
|
|
All IC’s supported by MPLAD IDE |
|
To add IC’s Download new version of MPLAB IDE &
update your PIC-ICD-II |
|
The minimum requirements are as follows: |
|
A PC, IBM or compatible, desktop with one USB/Serial port. |
|
Win98 SP2/NT/2000/ME/Xp |
|
CD-ROM driver |
|
Hard disk of at least 500MB of spare capacity |
|
|
PIC-ICD-II dimensions |
: |
80mm L x 125mm W x 25mm H |
|
Power supply |
: |
Input AC 100 to 240V, Output : DC 9V/500mA. |
|
Weight |
: |
115 gms |
|
1 year limited warranty |
|
